Primary chain inspection cover Primary Cover: 2007 Sportster Models Changing Lubricant 1. Wear a protective face shield, rubberized gloves and protective clothing when working with batteries. Failure to do so can draw debris into the engine and could result in engine damage. The range of a pager can be up to 0. The license plate assembly must be in the extended position during operation. In some cases, small punctures in the tread area may be repaired from within the demounted tire by a HarleyDavidson dealer. Momentarily depress the desired turn signal switch.
Ground Jump Start Cable Connections Electrical Protection: Sportster Models Fuse Replacement 1. Force of 10 lbs 4. Use of motorcycles other than Touring models with sidecars could result in death or serious injury. Brake fluid level and condition. If you operate the vehicle under these conditions, the exhaust will become abnormally hot, which can cause vehicle damage, including emission control loss. Interchanging front and rear tires can cause tire failure, which could result in death or serious injury.
Verify that lubricant level is even with bottom of clutch diaphragm spring. The left side cover is secured to the motorcycle by two upper slots that fit into upper clips 2 and a bottom slot 3 that fits into a mounting tab on the battery tray. Continuous use of brake causes overheating and reduced efficiency, which could result in death or serious injury. Negative Cable Do not connect negative cable to or near the discharged battery negative terminal. Refuel in a well ventilated area with the engine turned off.
Adjust to proper inflation pressure. Aftermarket fasteners can adversely affect performance, which could result in death or serious injury. When activated, the Smart Security System will: Alternately flash the four turn signals. Mounting plate Applying Thin Oil Film Winter Lubrication In colder climates, the engine oil should be changed often. All controls should operate freely without binding. Remove and inspect the spark plugs.
Do not leave the fob attached to the handlebars or store the fob in a saddlebag or Tour. This will allow the engine to warm up and let oil reach all surfaces needing lubrication. Check brake pads and brake discs for wear at proper intervals. Check the spark plugs at proper intervals. Bright or light colors are best for greater visibility in traffic, especially at night. If the clutch is not disengaged, the vehicle will not start.
After a new motorcycle has been ridden its first 1000 miles 1600 kilometers , it should be taken to an authorized Harley Davidson dealer for initial service operations. If swallowed, obtain medical attention. Aftermarket fasteners may not have the specific property requirements to perform properly. This prohibition applies prior to vehicle sale or delivery to the ultimate purchaser. Wipe filter gasket contact surface of oil filter mount with a clean cloth.
Dirt and electrolyte on top of the battery can cause battery to selfdischarge. The clutch hand lever 1 is located on the left handlebar and is operated with the fingers of the left hand. The horn is operated by pushing on the horn switch 2 located on the left handlebar control group. Inspect the battery for discoloration, a raised top or a warped or distorted case. To protect the vehicle's body panels, engine, chassis and wheels from corrosion, follow the cosmetic care procedures described in the Accessory Maintenance section of this owner's manual prior to storage. With negative cable disconnected from grounding point on crankcase, insert bolt through MaxiFuse cable first then through main battery positive cable + red and into threaded. To maintain possession of the fob, ask the dealer to disable the module for service service mode before leaving the dealership.
Charging Never charge a battery without first reviewing the instructions for the charger being used. See Upshift Sequence: Sportster Models. Electrolyte leakage will damage motorcycle parts. Refer to Primary Chain Adjustment: Sportster Models. Ease out the clutch lever and gradually open the throttle. Tighten headlamp clamp nut to 120240 inlbs 1427 Nm after lamp is properly positioned.
If your combined electrical accessories operating at any one time consume more electrical current than your vehicle's charging system can produce, the electrical consumption can discharge the battery and cause vehicle electrical system damage. Batteries contain sulfuric acid, which could cause severe burns to eyes and skin. Check the fluid level in the master cylinder reservoirs at regular intervals. When disarming, the siren responds with a single chirp. When the engine has started, you can operate your motorcycle as you normally would after raising the jiffy stand. If swallowed, obtain medical attention. Overtightening can lead to loss of vehicle control, which could result in death or serious injury.
It is possible to overload your motorcycle's charging. Use of certain other manufacturer's performance parts will void your new motorcycle warranty. Fill fuel tank and add a gasoline stabilizer. Charge the battery if any of the following conditions exist: Vehicle lamps appear dim. Press top of side cover into clips until snug.