This includes no air conditioning, steel seat belt mounting frame and roll hoop, and chassis rear brace kit. ·lbf 15 153, 11 118 1,204, 87 18 178, 13 10 102, 89 in. S Immediately remove nozzle from the tube and reinstall cap. Hopefully I can fit my xhaust on Saturday!! Connecting rod bearing center wall thickness Reference Mark 1 Mark 2 Mark 3 1. S Head warpage or cracking could result from removing bolts in an incorrect order.
S Parts must be assembled within 3 minutes of application. However the manuals needed for the Elise are available in Europe at the Belgium website. If out--of alignment is greater than maximum, replace the connecting rod assembly. Connecting rod oil clearance Standard Maximum 0. Crankshaft Thrust washer thickness 2. The manual is available as high quality pdf documents. If damages are found on the camshaft thrust surfaces, the camshaft also has to be replaced.
S Thoroughly clean all components to remove all the loose material. Valve clearance Cold Intake 0. Removing and Installing, Replacing, Disassembling, Installing and Checking, Adjusting 3. S Follow the directions when the manual instructs the position and direction. Torque: 35 Nbm 357 kgfbcm, 26 ftblbf c Mark the front of the cylinder head bolt with paint.
It often causes the breakage of the lock pin. Front side b Remove the oil control valve filter. The price is 16 Euros at Be prepared to take a long time to download the manuals as they are listed as individual chapters. The task heading can be read at a glance when necessary, and the text below provides detailed information. Remove the 10 cylinder head bolts and plate washers. Then apply the specified seal lock adhesive to the bolt, nut or threads.
S Immediately remove nozzle from the tube and reinstall cap. If the lining should become detached from the cant rails, it should be re-fixed using mechanical clamping for improved security. Fix the parts through aluminum bar. If necessary, replace the cylinder block. S Do not put into engine oil 2 hours after installing. I have included some in the miscellaneous section of the information pages. If the oil clearance is greater than maximum.
Valve stem diameter: Intake 5. ·lbf Camshaft Sub Gear Camshaft, No. S Immediately remove nozzle from the tube and reinstall cap. Starter brush holder assy Brush length Standard Minimum 14 mm 0. S Parts must be assembled with in 3 minutes of application. Valve guide bush protrusion height 15.
They will be used later to determine the required replacement adjusting shim. Piston ring groove clearance 0. Otherwise the material must be removed and reapplied. S Parts must be assembled within 3 minutes of application. Always use a torque wrench.
If the thickness is not specified, replace the thrust washer. Reference: Standard bearing center wall thickness Mark mm in. S Make sure that the camshaft is in the same condition as step 1. Crank pin diameter Maximum taper and out--of-round 44. Lotus electronic traction control 2.
Protrusion height: A: 5 mm 0. Cylinder head warpage Maximum Cylinder block side Intake manifold side Exhaust manifold side 0. Starter yoke assy Brush length Standard Minimum 14 mm 0. Valve rocker shaft diameter 15. Crankshaft thrust clearance Standard Maximum 0. Camshaft circle runout Maximum 0. .